General Category > General Discussion
Connecting FT4232H to a Raspberry Pi 4 - no detection
(1/1)
Astoca:
I was hoping to get
FT4232H ( USB mini B uart)
Raspberry Pi Linux raspberrypi 5.10.63-v8+ aarch64 GNU/Linux
Edit: OS: Debian GNU/Linux, Versiojn=-10 (buster)
working together.
The Linux installation guide suggests if I'm reading it correctly that they expect that Linux will automatically detect and connect FTDI modules.
https://ftdichip.com/wp-content/uploads/2020/08/AN_220_FTDI_Drivers_Installation_Guide_for_Linux-1.pdf
page 3: 1.1 "Since the FTDI VCP driver is built into the Linux kernel ... "
When I connect the module and type at the terminal
demsg | grep FTDI
It returns nothing. In other words, This linux kernel isn't detecting and connecting the FTDI module automatically, and no text in the demsg output contains "FTDI".
I am unsure where to go next with this and was hoping someone might have experience connecting these devices to a Raspberry Pi 4
If I can avoid using the D2xx drivers in favour of built in kernel support (VCP) I'll take the VCP ideally.
FTDI Community:
Hello,
what version of Linux are you using? our Linux VCP drivers can be downloaded from our website https://ftdichip.com/drivers/vcp-drivers/.
are you sure that the FT4232H mini module being powered correctly? depending on the power configuration you are using, there are some external connections needed. Section 3 of the module datasheet explains this https://ftdichip.com/wp-content/uploads/2020/07/DS_FT4232H_Mini_Module.pdf.
Best Regards,
FTDI Community.
Navigation
[0] Message Index
Go to full version