1
Discussion - Software / Re: Cannot flash a firmware via VNC2 Debug Module
« on: February 18, 2020, 04:30:51 AM »
Hello!
Okay, I was using VNC2 Debugger with VCP driver.
I need to use D2XX drivers but it may disable any software using COM ports, right?
>This can be changed in the EEPROM using FT_Prog which would make this change permanent.
>It can also be done at Windows device manager level, but the option would only exist for that particular installation.
So does it means that I need to rewrite VID/PID on the EEPROM on VNC2 Debugger?
Would you teach me the way to do it or give any documentations?
>Can you also try programming directly within the IDE?
It also doesn't work correctly...
>Vinculum/Vinculum-II are very mature products and are no longer supported by R&D and has been superseded by FT9xx.
>The best solution we have is our FT90x MCU.
Thank you for your information! I will consider about using FT90x series.
But now I need to use VNC2 for the prototype of new product...
Okay, I was using VNC2 Debugger with VCP driver.
I need to use D2XX drivers but it may disable any software using COM ports, right?
>This can be changed in the EEPROM using FT_Prog which would make this change permanent.
>It can also be done at Windows device manager level, but the option would only exist for that particular installation.
So does it means that I need to rewrite VID/PID on the EEPROM on VNC2 Debugger?
Would you teach me the way to do it or give any documentations?
>Can you also try programming directly within the IDE?
It also doesn't work correctly...
>Vinculum/Vinculum-II are very mature products and are no longer supported by R&D and has been superseded by FT9xx.
>The best solution we have is our FT90x MCU.
Thank you for your information! I will consider about using FT90x series.
But now I need to use VNC2 for the prototype of new product...