271
General Discussion / Re: FT813_Riverdi display 7 inch
« on: July 29, 2021, 02:43:54 PM »
Hello,
Thank you for the update.
I have had a quick look at the pinout for the module you are using and the pin out on the LCD connector on the click board, it appears that these do not match. For example the CS# signal is pin 3 on the LCD, but it is pin 6 on the Click board. Riverdi should be able to confirm this for you, but I suspect a mismatch in signal assignments is the root cause of the issue currently.
As for your second question, no toggling the PD pin is optional during the boot sequence, however we would recommend implementing this functionality via a GPIO pin if possible.
Best Regards,
BRT Community
Thank you for the update.
I have had a quick look at the pinout for the module you are using and the pin out on the LCD connector on the click board, it appears that these do not match. For example the CS# signal is pin 3 on the LCD, but it is pin 6 on the Click board. Riverdi should be able to confirm this for you, but I suspect a mismatch in signal assignments is the root cause of the issue currently.
As for your second question, no toggling the PD pin is optional during the boot sequence, however we would recommend implementing this functionality via a GPIO pin if possible.
Best Regards,
BRT Community