General Category > Discussion - Hardware
Reverse UART RX/TX in the FTDI Dual Channel FT2232H chip
(1/1)
adnanhuxain:
I have used the FT2232H chip to make my own custom module and I made the wrong connection with the TX/RX. Are there any ways to swap/reverse the UART TX/RX in the FT2232H? In the FT_Prog, I couldn't see the option to reverse TX/RX so I am assuming that reversing is not possible in the FT2232H?
FTDI Community:
Hi
You could invert these signals using the FT prog utility.
From the "hardware specific" section there is an "Invert RS232 signals" section. TX/RX can be inverted from there.
Regards
FTDI Community
adnanhuxain:
I don't see that option in the FT_Prog. Please check the image attached below. I am using the FT2232H dual channel UART chip
cioma:
Reversing (swapping) of UART RX and TX is not possible in the FT2232H
Navigation
[0] Message Index
Go to full version