1
Discussion - Software / How do I configure FT232H device for I2C interface using FT_PROG
« on: October 22, 2020, 03:38:30 PM »
Hi,
I'm trying to program FT232H device to work above I2C bus. I connected Logic to the orange wire (SCL) and the yellow wire (SDA data out, currently the green wire is disconnected), but the clock signal is wrong.
I guess that my problem relate to the configuration of FT232H device.
Could someone advise me how to configure the Template to perform correct I2C transaction.
Thanks,
Itamar
I'm trying to program FT232H device to work above I2C bus. I connected Logic to the orange wire (SCL) and the yellow wire (SDA data out, currently the green wire is disconnected), but the clock signal is wrong.
I guess that my problem relate to the configuration of FT232H device.
Could someone advise me how to configure the Template to perform correct I2C transaction.
Thanks,
Itamar