FTDI Community
General Category => Discussion - Software => Topic started by: stoll on February 21, 2022, 07:02:48 PM
-
hello
How can I read and save the program in vnc2 -48l flash
Is it possible with vinculum ii ide and VNC2 debug module
-
Hello,
Please see the following document: https://ftdichip.com/wp-content/uploads/2020/08/AN_159-Vinculum-II-Firmware-Flash-Programming.pdf (http://url).
this explains how the device can be flashed. Section 2 covers the IDE tool suite and section 3 explains how to program via the debugger interface.
This document will also to helpful to you: https://ftdichip.com/wp-content/uploads/2020/08/AN_138_Vinculum-II_Debug_Interface_Description.pdf (http://url).
This application note is dedicated to the description of the debug interface.
Here is some more useful documentation for you:
https://ftdichip.com/wp-content/uploads/2020/08/AN_137_Vinculum-II-IO_Cell_Description.pdf (http://url)
https://ftdichip.com/wp-content/uploads/2020/08/AN_142_Vinculum-II_Tool_Chain_Getting_Started_Guide.pdf (http://url)
https://ftdichip.com/wp-content/uploads/2020/08/AN_144_Vinculum-II_IO_Mux_Config_Utility_User_Guide.pdf (http://url)
Best Regards
FTDI Community
-
thank you so much
my goal is to get the pre-installed program from vnc2-48l1c flash and convert it to a file.
if I can do it, of course
-
Hello,
if you can email in at support1@ftdichip.com we have something that might help you.
Best regards
FTDI Community
-
I sent
thank you very much for your attention
Best regards