827
« on: May 31, 2018, 11:57:41 am »
Hi,
I notice that you also sent this question to our email support channel and that you have received a reply.
For completeness below is the reply that was sent:
Sorry that the pin number 32 (ACBUS 8 ) 33 (ACBUS 9) cannot be accessed under CPU-FIFO mode. if you want to access them, you need to switch the operation mode into the CBUS bitbang mode. but I don’t think it’s what you expected.
I suggest that you select async FIFO mode for your application due to it use the same HW bus as the CPU-FIFO mode but it works more efficient.
Due to the FT232H works as the slave device under the async FIFO mode, your CPU control the data access timing and it’s not necessary to inform the FT232H that the data transfer is done.
Please continue any further discussion with the email support channel.
Best Regards,
FTDI Community