FTDI Community
General Category => Discussion - Drivers => Topic started by: cioma on August 31, 2020, 11:56:17 am
-
If my FT231X CBUS[0:3] pins are configured as "GPIO" in MTP can I control them (configure as input or output, write and read pin values) from Java D2xx library for Android?
-
Hello,
Here is our application note for CBUS bit bang on the FT-X series
https://www.ftdichip.com/Support/Documents/AppNotes/AN_373%20Bit-Bang%20Modes%20for%20the%20FT-X%20Series.pdf (https://www.ftdichip.com/Support/Documents/AppNotes/AN_373%20Bit-Bang%20Modes%20for%20the%20FT-X%20Series.pdf)
The Java D2xx FT_SetBitMode was only tested for CBUS bit bang on the FT232R and FT232H devices but should also work on the FT-X.
Best Regards, FTDI Community