FTDI Community
General Category => Discussion - Hardware => Topic started by: ilya79 on August 16, 2018, 10:50:31 AM
-
Hi! FT601datasheet (table 4.2 FIFO Bus AC timing) points that in worst case slave drive sata set up time is 3 ns. In AN_421 document (FIFO Bus Master for FT60x application note) on page 19, in timing constraints this parameter is set to 6 ns (TIMEGRP "M_FIFO_IO" OFFSET = IN 6 ns VALID 6.5 ns BEFORE "CLK" RISING). What value is correct ?
-
Hello,
Please can you contact email support on support1@ftdichip.com and we will look into this, the outcome of which we will post here.
Regards,
FTDI Community
-
Hi, just curious, what was the outcome of this?