886
Discussion - Hardware / Re: Problems with UMFT601X-B, trying to connect it to KC705 (Kintex-7 board)
« on: October 18, 2017, 09:11:42 AM »
Hi Anton,
Could you please check whether the board is connected to a USB2 or USB3 port when doing the programming?
The utility requires a USB3 port in order to program the device and the error from a USB2 port looks the same as the one you mentioned here.
The board can be recovered by connecting to a USB3 port and repeating the programming and should then show up correctly programmed with your new settings.
Best Regards
FTDI Community
Could you please check whether the board is connected to a USB2 or USB3 port when doing the programming?
The utility requires a USB3 port in order to program the device and the error from a USB2 port looks the same as the one you mentioned here.
The board can be recovered by connecting to a USB3 port and repeating the programming and should then show up correctly programmed with your new settings.
Best Regards
FTDI Community