376
Discussion - Hardware / Re: FT312 Woes
« on: December 22, 2020, 04:31:07 PM »
Hello,
Please check the status of the USB_ERROR# pin.
Refer to the FT312D Datasheet for more information on this.
Also, where is your 3.3V supply originating from?
As per the datasheet, this should originate from the 5V USB Host Supply with a 3.3V regulator.
The crystal load capacitors need the correct capacitance value for your chosen crystal. is 5pF the correct value?
You can speak to the crystal manufacturer about this.
Best Regards,
FTDI Community
Please check the status of the USB_ERROR# pin.
Refer to the FT312D Datasheet for more information on this.
Also, where is your 3.3V supply originating from?
As per the datasheet, this should originate from the 5V USB Host Supply with a 3.3V regulator.
The crystal load capacitors need the correct capacitance value for your chosen crystal. is 5pF the correct value?
You can speak to the crystal manufacturer about this.
Best Regards,
FTDI Community