1
Discussion - Software / FT312D how to tell if config has already been sent ?
« on: January 08, 2019, 10:51:50 AM »
Hi
I'm using a FT312D based accessory and I couldn't find anywhere in the documentation or in the provided source code if there is a way to know from the andrdoid device if an attached accessory has been configured already (setConfig) and if it is possible to reconfigure without physically disconnecting the accessory.
I noticed there seem to be a special case when writing 64 bytes to the output stream but couldn't find it documented anywhere.
I'm using a FT312D based accessory and I couldn't find anywhere in the documentation or in the provided source code if there is a way to know from the andrdoid device if an attached accessory has been configured already (setConfig) and if it is possible to reconfigure without physically disconnecting the accessory.
I noticed there seem to be a special case when writing 64 bytes to the output stream but couldn't find it documented anywhere.