General Category > General Discussion

1 USB to 3 UART using FT4232H

<< < (2/2)

FTDI Community:
Hello,

I would suggest the simplest solution is to connect the UART channels of device 0 and device 1 together if you just require a simple UART bridge.

Assuming however, that you also require a USB connection to these devices, utilising the FT4232H you would be required to write a software application that echos data back and forth between the desired COM ports/interfaces on the FT4232H. You could achieve this using standard COM port programming techniques, or via our D2XX DLL.

Best Regards,
FTDI Community

Navigation

[0] Message Index

[*] Previous page