FTDI Community

General Category => Discussion - Drivers => Topic started by: Scott Chiu on July 26, 2023, 04:09:39 AM

Title: Is it possible to connect a vendor specific device(0xFF) to the V2DIP2 module?
Post by: Scott Chiu on July 26, 2023, 04:09:39 AM

Hello,
Is it possible to connect a vendor-specific device to the V2DIP2 module? I want to use VNC2 as the host to communicate with a WinUSB device. Is there an example available to demonstrate how to write the firmware driver?

Title: Re: Is it possible to connect a vendor specific device(0xFF) to the V2DIP2 module?
Post by: FTDI Community on July 27, 2023, 10:55:11 AM

Hi Scott,

The only vendor class devices supported by VNC2 are FTDI vendor class devices.

You should have a look at the FT90x series that is made by our sister company Bridgetek. FT90x is a programmable host controller, like VNC2, however it is open source so you can create your own software.

Best Regards
FTDI Community