1
Discussion - Software / Re: What is VCOM functionality exactly?
« on: October 26, 2022, 07:00:04 AM »Hello,
Which VNC2-48 Development Module and USB to UART bridge are you using exactly?
Please see AN_159 Vinculum-II Firmware Flash Programming which should help you.
Note that when programming VNC2 via UART, to enable bootloader mode, the PROG# pin must be driven low and VNC2 must
then be reset by driving the RESET# pin low then high.
I have tested this here and it works as expected:
Best Regards,
FTDI Community
Hi, I am using vnc2-48L1C and I am using ft232RL to program VNC2 via usb