1
Discussion - Hardware / Re: FT813 power pin inssue
« on: October 31, 2020, 03:04:05 pm »
PD is to be connected to a GPIO output.
You could leave it open but issuing a core-reset command would be required for a proper warm-start then.
Check out my code library:
https://github.com/RudolphRiedel/FT800-FT813
EVE_commands.c has EVE_init(), line 1177ff.
You could leave it open but issuing a core-reset command would be required for a proper warm-start then.
Check out my code library:
https://github.com/RudolphRiedel/FT800-FT813
EVE_commands.c has EVE_init(), line 1177ff.