General Category > Discussion - Software

Display issues with Special character

(1/1)

NW27:
Hi,
I'm using the MikroC compiler to program a FT90x and FT812 display.
When I write the following to the display "°C", the display severely breaks up with missing text/boxes and squiggly lines displayed. The issue is the "°" degree symbol. If I leave this out, the display works perfectly. If I write "DegC" it works perfectly (point being that it is not a string size issue).
Is there an issue with the FT812 displaying special characters?

Thanks,
Neil.

P.S. Does every post have to be approved by a moderator?

FTDI Community:
Hi,

Could you provide further information about how you created the degree symbol and how you use it in your code.

Did you create a custom font containing the ASCII character set plus some special symbols such as degrees?

You can also send any code or details to our support address below if you prefer
support1@ftdichip.com

Best Regards, FTDI Community

Navigation

[0] Message Index