General Category > Discussion - Software

flash backup

(1/1)

stoll:
hello
How can I read and save the program in vnc2 -48l flash
Is it possible with vinculum ii ide and VNC2 debug module

FTDI Community:
Hello,

Please see the following document: https://ftdichip.com/wp-content/uploads/2020/08/AN_159-Vinculum-II-Firmware-Flash-Programming.pdf.

this explains how the device can be flashed. Section 2 covers the IDE tool suite and section 3 explains how to program via the debugger interface.

This document will also to helpful to you: https://ftdichip.com/wp-content/uploads/2020/08/AN_138_Vinculum-II_Debug_Interface_Description.pdf.

This application note is dedicated to the description of the debug interface.

Here is some more useful documentation for you:

https://ftdichip.com/wp-content/uploads/2020/08/AN_137_Vinculum-II-IO_Cell_Description.pdf

https://ftdichip.com/wp-content/uploads/2020/08/AN_142_Vinculum-II_Tool_Chain_Getting_Started_Guide.pdf

https://ftdichip.com/wp-content/uploads/2020/08/AN_144_Vinculum-II_IO_Mux_Config_Utility_User_Guide.pdf

Best Regards

FTDI Community

stoll:
thank you so much

my goal is to get the pre-installed program from vnc2-48l1c  flash and convert it to a file.

if I can do it, of course

FTDI Community:
Hello,

if you can email in at support1@ftdichip.com we have something that might help you.

Best regards

FTDI Community

stoll:

I sent

thank you very much for your attention

Best regards

Navigation

[0] Message Index