1
Discussion - Drivers / Re: Reading data from FT232h via FT2XX driver - data loss on Raspberry Pi
« on: December 11, 2017, 03:51:57 PM »
Still no solution found...
Is there a way to check if buffer flags are activated in the D2XX ARM driver? The hardware design obviously supports these (as mentioned before, the test runs on a Windows workstation).
Or shall I contact FTDI support via E-Mail?
Is there a way to check if buffer flags are activated in the D2XX ARM driver? The hardware design obviously supports these (as mentioned before, the test runs on a Windows workstation).
Or shall I contact FTDI support via E-Mail?