General Category > Discussion - Software

Communication with the FT4222 using Matlab

(1/1)

Cactus:
Hi all,
I was wondering if anyone had any experience initializing and using for SPI communications the FT4222 only using the D2XX drivers.
I am looking to use this chip interfacing with Matlab, however I have only been able to successfully load the D2XX libraries, not the FT4222 libraries.
Cheers

FTDI Community:
Hello,

The FT4222H can not be used with the D2XX drivers alone, it must also be used with libFT4222 which can be downloaded here:

http://www.ftdichip.com/Products/ICs/FT4222H.html

You will also find code examples provided with the libFT4222.

Best Regards,
FTDI Community

Cactus:
Hi Guys,
Thanks for the reply
Cheers

SwissGuy:
Hi Everyone

Has anyone of you been successful until now with writing a matlab driver for the FT4222 chip?

Cheers

Cactus:
Hi SwissGuy,
I was unable to get a matlab driver sorted out. Struggled for quite a bit but then I was able to get it sorted on Labview so gave up.
Cheers

Navigation

[0] Message Index