FTDI Community
General Category => Discussion - Hardware => Topic started by: t0nyl2 on May 08, 2020, 03:54:33 PM
-
To use the TESTMODE (50h) and TESTPMSET1/2 (70h/74h) on the FT313H, must the TESTEN pin be pulled up?
Is it acceptable to have the TESTEN pulled down externally for normal operation or should it be left floating?
-
Hello,
As per the FT313H Datasheet (https://www.ftdichip.com/Support/Documents/DataSheets/ICs/DS_FT313H.pdf) TESTEN pin is to Enable test mode. It has an Internal pull-down.
For normal operation leave floating.
Best Regards,
FTDI Community