FTDI Community
General Category => Discussion - Hardware => Topic started by: adnanhuxain on March 24, 2022, 04:01:45 AM
-
I have used the FT2232H chip to make my own custom module and I made the wrong connection with the TX/RX. Are there any ways to swap/reverse the UART TX/RX in the FT2232H? In the FT_Prog, I couldn't see the option to reverse TX/RX so I am assuming that reversing is not possible in the FT2232H?
-
Hi
You could invert these signals using the FT prog utility.
From the "hardware specific" section there is an "Invert RS232 signals" section. TX/RX can be inverted from there.
Regards
FTDI Community
-
I don't see that option in the FT_Prog. Please check the image attached below. I am using the FT2232H dual channel UART chip
-
Reversing (swapping) of UART RX and TX is not possible in the FT2232H