FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Topics - wienni

Pages: [1]
1
Discussion - Software / USB3.0 communication error on FT601
« on: November 16, 2020, 01:32:28 AM »
Hello.
My project is in progress using USB3.0 Bridge, FT601Q-B.
The system block is PC <-> FT601Q <-> ARRIA10 FPGA.

The Loopback program, an example program of the FTDI, has been modified.
So I tested it by sending one packet, receiving an ACK signal, and sending the next packet.
However, there is a phenomenon in which data is not transmitted in the middle of packet transmission.
The details of debugging using the USB monitoring program are as follows and please check.

Q1.

WritingPage Failed stats[30] => 30 error code USB3.0 disconnection

WritingPage Failed stats[32] => 32... No error code
What kind of error is error code 32?

Q2.
When the packet is analyzed after an error occurs while data is being sent by 4k bytes each, URB FUCNTION CONTROL TRANSFER is sent from the PC as shown below.
When is this message sent?




If a clear answer is difficult, is the driver source available?

Please confirm.

Thank you.

Pages: [1]