FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Topics - GHOC3D

Pages: [1]
1
Hello,

I have a design that is using an FT2232H with channel A configured as JTAG, and channel B configured as I2C. On the JTAG channel, I wish to use one of the free pins as a GPIO to reset my board. I have looked through AN_184, table 5.1, and I see that, for example, the ACBUS1 pin is designated as 'Function' when the device is enumerated/active. But before any software intervention, what is the initial state of this pin? Is it driving high, driving low, or is it an input with pull-up/down? If it is pulled up or down, what is the resistance value?

My hope is that the GPIO pin is tristated initially, so I can pull it up or down on my PCB such that my reset signal is held inactive.

Thank you.

Pages: [1]