FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Topics - midaszhou

Pages: [1]
1
General Discussion / Widora_NEO: FT232H control signal for TFT Display
« on: December 07, 2017, 06:45:09 AM »
Hi,
I use ft232h to link a TFT display with a usb socket of my embedded device Widora_NEO ,  ft232h is set to async BITBANG mode , with D0~D7 for RGB data interface to the tft display. It works fine and usb speed can reache 12MBytes/s, you can play movie on the display. I use open source ftdi library in https://www.intra2net.com/en/developer/libftdi, and my test codes put here:  https://github.com/widora/ctest/blob/master/ft232_tft.c
 or refer to: http://sns.widora.cn/topic/296/widora-neo-%E9%80%9A%E8%BF%87usb%E7%8E%A9%E8%B7%91%E9%A9%AC%E7%81%AF%E5%92%8C%E6%8E%A5tft%E5%B1%8F/2

There is one problem however, a D/CX (data or command) control signal must send from my embedded device with an independent line, and I cann't figure out how to produce this siganl by FT232H itself.   
Attached is the timing sequence of  display control signal. The WRX signal accords with WRSTB# well.

Thanks.

Midas Zhou

Pages: [1]