1
Discussion - Hardware / Re: handshaking, flow control
« on: August 28, 2018, 08:35:07 PM »
Hello,
thank you very much for your answer.
I did not understand, I have to program the FT232BL for flow control to work, or I do not have to do anything.
In my application I have connected a MCU with Handshake-Signals to the FT232BL (like a PuTTY), but the Device does not respond to the signals.
There is no automatic control in my application. After Power on the RTS# is allways high at the FT232BL.
I have read the followed in FTDI Knowledgebase:
"If RTS# is logic 1 it is indicating the FTxxx device cannot accept more data".
That means In my case, I can never send data because RTS# is always high.
Regards Jürgen
thank you very much for your answer.
I did not understand, I have to program the FT232BL for flow control to work, or I do not have to do anything.
In my application I have connected a MCU with Handshake-Signals to the FT232BL (like a PuTTY), but the Device does not respond to the signals.
There is no automatic control in my application. After Power on the RTS# is allways high at the FT232BL.
I have read the followed in FTDI Knowledgebase:
"If RTS# is logic 1 it is indicating the FTxxx device cannot accept more data".
That means In my case, I can never send data because RTS# is always high.
Regards Jürgen