FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  


Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support

New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Messages - zeedel

Pages: [1]
Discussion - Hardware / Re: FT230XQ: Powering VCC with 3.3V
« on: February 05, 2020, 10:53:15 AM »
Thanks so much, the response has been very helpful. Indeed, I had overlooked the need for the 47pF edge rate control capacitors.

Discussion - Hardware / FT230XQ: Powering VCC with 3.3V
« on: February 04, 2020, 10:36:34 AM »

I am integrating the FT230XQ chip into my design, and am powering VCC with 3.3V (regulated from USB_VBUS). Consequently, I followed the datasheet which states "3V3OUT on pin 8 is an input pin and should be connected to pin10". Please could you advise whether the attached schematic is correct? I should highlight that the 3.3V rail supplying VCC, VCCIO, and 3V3OUT is derived from USB_VBUS using an LDO regulator.


Pages: [1]