FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Messages - VVasa

Pages: [1]
1
Thanks for instant reply
FT2232 is entirely self-powered so in schematic if you see VBUS connection on pin 59 is from internally generated 5V regulatory & with same supply we are generating 3.3V, so I think there should not be any issue with Power sequence because all three VCC,VCCIO & RESET are generated at same time.

Also we have a continuous supply of 3.3V on PWRSAV pin 59 & hence I don't think chip is in power down mode. But still FT2232H is not able to enuemerate the USB port. I saw that out 50-60 times I got one time Enuemeration of FTDI chip during that time I measured Clock which was showing 12Mhz & also measured the Suspend pin was showing at Normal Operation. After that I had never got USB enumeration

2
Hi Team

I am using Ft2232h with my Custom design board. I observed that my pin no.60 (PWREN) is showing 3.3V & pin 36 (Suspend) is showing 0V, I assume that my FTDI is probably in suspend mode and hence not able to get detected on my Windows/Linux system.

I have attached snap from my Schematic. I have observed the following thing:
- Voltage wise its perfect getting 3.3V & 1.8V(VCORE)
- Have checked the assembly wise & its ok
- Also checked by Removing EEPROM
- Many times I have observed Device descriptor failed error message on Windows machine

Questioners:
- Whenever the power ON condition happens does FT2232H needs any particular sequence ?
- What will be the Crystal Frequency to be observed at Oscillator pin's 2 & 3?

Can you please guide through on what can be the solution to remove FT2232H out from Suspend mode ?

Pages: [1]