FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team @ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Messages - FTDIUser1

Pages: [1]
1
General Discussion / Re: Ft260q-t instead of ft232r
« on: October 05, 2021, 01:32:46 AM »
Hello,

According to datasheet, DCNF0 pin should be set to high and DCNF1 set to low in order to enable UART communication. Is there any other configuration I should consider to allow the IC to act as TTL-232R cable converter?

Thank you,

2
General Discussion / Ft260q-t instead of ft232r
« on: September 30, 2021, 07:35:48 PM »
Hello everyone,

I am working on a project that need an FT232r cable to convert UART to USB. The cable work fine but we are planning to use an IC on the board instead. Unfortunately, FT232 ICs are out of stock everywhere.

Is it possible to use FT260 instead ? we don't need a specific application. Only convert UART to USB.

Thank you,

Pages: [1]