FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Messages - Takumi Ando

Pages: [1]
1
Discussion - Software / Re: Cannot flash a firmware via VNC2 Debug Module
« on: February 18, 2020, 04:30:51 AM »
Hello!

Okay, I was using VNC2 Debugger with VCP driver.
I need to use D2XX drivers but it may disable any software using COM ports, right?

>This can be changed in the EEPROM using FT_Prog which would make this change permanent.
>It can also be done at Windows device manager level, but the option would only exist for that particular installation.

So does it means that I need to rewrite VID/PID on the EEPROM on VNC2 Debugger?
Would you teach me the way to do it or give any documentations?

>Can you also try programming directly within the IDE?

It also doesn't work correctly...

>Vinculum/Vinculum-II are very mature products and are no longer supported by R&D and has been superseded by FT9xx.
>The best solution we have is our FT90x MCU.

Thank you for your information! I will consider about using FT90x series.
But now I need to use VNC2 for the prototype of new product...

2
Discussion - Software / Cannot flash a firmware via VNC2 Debug Module
« on: February 13, 2020, 02:46:32 AM »
Hello!

I'm developing V2DIP1-3D with VNC2 Debug Module.
But they don't work correctly...
I cannot flash a firmware via the debugger.

I tried FT_Prog and V2Prog, but both failed with errors.
Did I miss something?

BR,

Pages: [1]