General Category > Discussion - Software

FT312D how to tell if config has already been sent ?

(1/1)

gpf:
Hi
I'm using a FT312D based accessory and I couldn't find anywhere in the documentation or in the provided source code if there is a way to know from the andrdoid device if an attached accessory has been configured already (setConfig) and if it is possible to reconfigure without physically disconnecting the accessory.
I noticed there seem to be a special case when writing 64 bytes to the output stream but couldn't find it documented anywhere.

FTDI Community:
Hello,

All of the available FT312D documentation can be found at the following:
https://www.ftdichip.com/Products/ICs/FT312D.html

Best Regards,
FTDI Community

Navigation

[0] Message Index