FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Author Topic: FT312D how to tell if config has already been sent ?  (Read 451 times)

gpf

  • Newbie
  • *
  • Posts: 1
    • View Profile
FT312D how to tell if config has already been sent ?
« on: January 08, 2019, 10:51:50 AM »

Hi
I'm using a FT312D based accessory and I couldn't find anywhere in the documentation or in the provided source code if there is a way to know from the andrdoid device if an attached accessory has been configured already (setConfig) and if it is possible to reconfigure without physically disconnecting the accessory.
I noticed there seem to be a special case when writing 64 bytes to the output stream but couldn't find it documented anywhere.
Logged

FTDI Community

  • Administrator
  • Sr. Member
  • *****
  • Posts: 278
    • View Profile
Re: FT312D how to tell if config has already been sent ?
« Reply #1 on: January 08, 2019, 01:34:11 PM »

Hello,

All of the available FT312D documentation can be found at the following:
https://www.ftdichip.com/Products/ICs/FT312D.html

Best Regards,
FTDI Community
Logged