General Category > Discussion - Hardware
continuous clock?
(1/1)
ost:
Is there any way to set FT2232H to output continous (stable) clock on SCK pin? I would like it to execute MPSSE commands on top of this, synchronized to the SCK edge like normal, shifting in and out on active CS only.
FTDI Community:
Hello,
Unfortunately it would not be possible to produce a continuous Clock signal using MPSSE commands. At some point the MPSSE commands would be split across a USB packet, the timing of USB packets is not deterministic and this will result in a pause with your Clock signal. The MPSSE functionality was designed as a clocking engine for data and not to run continuously.
Best Regards,
FTDI Community
Navigation
[0] Message Index
Go to full version