FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Author Topic: VinculumII- SPI in V2DAP long time for read status 0  (Read 119 times)

chicoprojeto

  • Newbie
  • *
  • Posts: 1
    • View Profile
VinculumII- SPI in V2DAP long time for read status 0
« on: March 14, 2019, 05:37:52 PM »

Good afternoon!
My VNC2 is configured as IPA and SCS. And I'm communicating via SPI.
When VNC2 reboots it only sends the prompt (0x3 and 0x0d).

As soon as I start VNC2 I read the 2 bytes that are in memory and this takes approximately 500us.

Then I open the opw file in approximately 2ms, but to read the return I take approximately 16ms, this is because the status always comes in 1 and I request the byte again until the status comes with 0 ... Can anyone here help me? Looks like some sync problem. That way, I'm taking too long to burn 8MBytes on a flash drive for about 30 minutes, I'd like to cut back on that time.

The software I recorded in vnc2 is what you have enabled on the site:
"FTDI \ Firmware \ Samples \ V2.0.2-SP2 \ VNC1L \ V2DAP"
Logged