FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Author Topic: 245 FIFO modes: Ok for WR to remain high between writes? (FT240X, FT245)  (Read 45 times)

Jaholmes

  • Newbie
  • *
  • Posts: 2
    • View Profile

I'm building a USB sensor application using discrete logic--no MCU or CPU.  I have a few candidate designs drawn up, and noticed that I could simplify things if it was permissible to keep WR normally high, then pulse low-high to write.  Datasheets for the FT240X and FT245 are a bit ambiguous about this.  I should mention that I'm also reading bytes, so RD must also being pulsed low-high periodically.  Can this happen while WR is held high--without anything bad happening?  Or must WR be low to read?  I'd guess it would be ok, but figure I ought to put it out there just in case.

Very best,
Aaron
« Last Edit: December 02, 2019, 07:02:30 PM by Jaholmes »
Logged