General Category > Discussion - Hardware
FT313H Test mode vs Normal mode
(1/1)
t0nyl2:
To use the TESTMODE (50h) and TESTPMSET1/2 (70h/74h) on the FT313H, must the TESTEN pin be pulled up?
Is it acceptable to have the TESTEN pulled down externally for normal operation or should it be left floating?
FTDI Community:
Hello,
As per the FT313H Datasheet TESTEN pin is to Enable test mode. It has an Internal pull-down.
For normal operation leave floating.
Best Regards,
FTDI Community
Navigation
[0] Message Index
Go to full version