General Category > Discussion - Drivers

NOOB 0 devs from FT_CreateDeviceInfoList

(1/1)

namklak:
Hi,
I'm a bare metal embedded C programmer/hardware guy forced to help a friend with a startup - I'm trying to write a driver for Linux (Linux is where I'm a noob).

Device info
[413395.811848] usb 2-1: new full-speed USB device number 9 using xhci_hcd
[413395.968277] usb 2-1: New USB device found, idVendor=0403, idProduct=6015, bcdDevice=10.00
[413395.968281] usb 2-1: New USB device strings: Mfr=1, Product=2, SerialNumber=3
[413395.968284] usb 2-1: Product: MK3-USB Interface
[413395.968285] usb 2-1: Manufacturer: VictronEnergy
[413395.968287] usb 2-1: SerialNumber: HQ1901RBVH3
[413395.972452] ftdi_sio 2-1:1.0: FTDI USB Serial Device converter detected
[413395.972510] usb 2-1: Detected FT-X
[413395.973142] usb 2-1: FTDI USB Serial Device converter now attached to ttyUSB0

I'm writing a little test driver that uses DX33.  When I call FT_CreateDeviceInfoList, I get 0 devices.

I can open /dev/ttyUSB0 and read some data, but I feel because I'm a linux rookie I should use the ftdi driver. 

Any ideas on why I see 0 devices?

Thanks,
-Namklak

Navigation

[0] Message Index