FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team
@ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Author Topic: Regarding FT260 HID-I2C Implementation using pywinusb HID driver  (Read 619 times)

suman.sinha

  • Newbie
  • *
  • Posts: 2
    • View Profile

Hi,
A few days ago, I was trying to interface the FT260 with ADC module using the LibFT260 drivers in C# and was able to execute it.
Now, I am using the pywinusb HID drivers to interface FT260 with ADC module using I2C. I am pretty much sure about the hardware as i have already implemented in C#.
Can you please help me in implementing HID-I2C for FT260 using pywinusb HID drivers?
Logged

suman.sinha

  • Newbie
  • *
  • Posts: 2
    • View Profile
Re: Regarding FT260 HID-I2C Implementation using pywinusb HID driver
« Reply #1 on: July 04, 2022, 10:30:12 AM »

Hi,

As per this documentation "AN_394_User_Guide_for_FT260",  the bit 7(as shown in figure 1) of the "Get system status" tells if the FT260 is configured as HID-I2C or not.

I am reading this value and always get 0 as shown in figure 2 although I have done the hardware configuration for DCNF0 and DCNF1 to select the mode of FT260 as I2C mentioned in "AN_438_FT260_I2C_Example_in_Csharp"(shown in figure 3)
 
Also i tried programming the FT260 through FT_Prog software as shown in figure 4("AN_399_FT260_HID-over-I2C"). To what value should i set it to enable the HID-I2C?
I am trying this for many days now as we are thinking to integrate the FT260 in our product. Can you please reply as soon as possible @FTDI COMMUNITY?
Logged