General Category > Discussion - Drivers

Is it possible to connect a vendor specific device(0xFF) to the V2DIP2 module?


Scott Chiu:
Is it possible to connect a vendor-specific device to the V2DIP2 module? I want to use VNC2 as the host to communicate with a WinUSB device. Is there an example available to demonstrate how to write the firmware driver?

FTDI Community:
Hi Scott,

The only vendor class devices supported by VNC2 are FTDI vendor class devices.

You should have a look at the FT90x series that is made by our sister company Bridgetek. FT90x is a programmable host controller, like VNC2, however it is open source so you can create your own software.

Best Regards
FTDI Community


[0] Message Index

Go to full version