1
Discussion - Software / Re: Vinculum II programming interface
« on: August 13, 2018, 07:47:59 pm »
Hi,
My colleague contacted the FTDI support via email. We are working on the same project.
We would like to program the VNC2 flash using an MCU which is on the same PCB. End users do not have the VNC2 debug module.
What we would like to know is how to make the connection between the MCU and VNC2 and see example code how to program the flash.
Some of our customers have had problems when the VNC2 has "lost" its firmware and they had to send us the PCB for reprogramming. It would be very beneficial for all of us if the MCU could reprogram the VNC2 flash.
In short, we would like to use our MCU as the VNC2 debug module.
My colleague contacted the FTDI support via email. We are working on the same project.
We would like to program the VNC2 flash using an MCU which is on the same PCB. End users do not have the VNC2 debug module.
What we would like to know is how to make the connection between the MCU and VNC2 and see example code how to program the flash.
Some of our customers have had problems when the VNC2 has "lost" its firmware and they had to send us the PCB for reprogramming. It would be very beneficial for all of us if the MCU could reprogram the VNC2 flash.
In short, we would like to use our MCU as the VNC2 debug module.