1
Discussion - Software / Re: FT245 control only using VCP e.g. doing all with a terminal program.
« on: December 12, 2019, 05:43:27 PM »
I have trawled the data sheets and can find no information regarding simple control/setup via the VCP port and a simple terminal programme. Please point me in the right direction. I am (and have) using FTDI serial devices on many projects, these work "out of the box" very well. All I need is the byte sequence to setup the 245 for simple on/off control of the output byte. Various "relay board demonstration" programmes work but I am stuck with a serial port only (it was hard enough to get the management to accept a VCP for the other ports). Sending bytes to the 245 after running a demo relay program works, not if I simply send the data after a cold reset.