1
General Discussion / Re: FT813_Riverdi display 7 inch
« on: July 29, 2021, 12:28:18 PM »
Hello,
Thanks for all your explanations.
Based on the examples, I tried to adapt the STM32 example to my MCU target. But it doesn't work yet.
I have some questions, first of all I want to know if my adapter is correct or not. I am using a riverdi click card (https://www.mikroe.com/riverdi-click) as an interface between the display and my S32K148 mcu, is this adapter correct? Or should I use another adapter?
Is the PD pin necessary to operate the display? Because in the adapter I don't have a PD pin.
Thank you again for your support.
Best regards.
Milad
Thanks for all your explanations.
Based on the examples, I tried to adapt the STM32 example to my MCU target. But it doesn't work yet.
I have some questions, first of all I want to know if my adapter is correct or not. I am using a riverdi click card (https://www.mikroe.com/riverdi-click) as an interface between the display and my S32K148 mcu, is this adapter correct? Or should I use another adapter?
Is the PD pin necessary to operate the display? Because in the adapter I don't have a PD pin.
Thank you again for your support.
Best regards.
Milad