1
Discussion - Software / Writing a page to flash stops the SPI from working
« on: September 20, 2023, 08:25:21 PM »
Tools: Vinculum ii IDE
Chip: 32pin VNC2
Application size has plenty of flash left, only at 227000 bytes.
For some reason when I write a single page of flash, the SPI device stops working... any ideas?
Basically this is all I am doing, then after that the SPI stops working. Tried other page locations. What is odd, is the flash write works. I can restart, and read the correct data from the flash.
flash_writePage(0x7ff, temp_string);
Chip: 32pin VNC2
Application size has plenty of flash left, only at 227000 bytes.
For some reason when I write a single page of flash, the SPI device stops working... any ideas?
Basically this is all I am doing, then after that the SPI stops working. Tried other page locations. What is odd, is the flash write works. I can restart, and read the correct data from the flash.
flash_writePage(0x7ff, temp_string);