61
Discussion - Software / Re: FT260 and LibFT260, using Interrupts
« on: April 13, 2023, 02:59:16 PM »
Hello,
The FT260 supports two I2C modes:
In USB-HID to I²C mode, the interrupt pin is spare and cannot be used.
It can't be used in UART mode either.
Best Regards,
FTDI Community
The FT260 supports two I2C modes:
- USB to HID-over-I2C Bridge
- USB to I2C master controller
In USB-HID to I²C mode, the interrupt pin is spare and cannot be used.
It can't be used in UART mode either.
Best Regards,
FTDI Community