121
Discussion - Software / Re: What is VCOM functionality exactly?
« on: October 14, 2022, 03:52:34 PM »
Hello,
Which VNC2-48 Development Module and USB to UART bridge are you using exactly?
Please see AN_159 Vinculum-II Firmware Flash Programming which should help you.
Note that when programming VNC2 via UART, to enable bootloader mode, the PROG# pin must be driven low and VNC2 must
then be reset by driving the RESET# pin low then high.
I have tested this here and it works as expected:
Best Regards,
FTDI Community
Which VNC2-48 Development Module and USB to UART bridge are you using exactly?
Please see AN_159 Vinculum-II Firmware Flash Programming which should help you.
Note that when programming VNC2 via UART, to enable bootloader mode, the PROG# pin must be driven low and VNC2 must
then be reset by driving the RESET# pin low then high.
I have tested this here and it works as expected:
Best Regards,
FTDI Community