691
Discussion - Software / Re: need to receive data stream from FT602 for non-video purpose
« on: March 20, 2019, 02:02:41 PM »
Hello,
The FT602 UVC Class SuperSpeed USB Bridge device provides a 32 bit parallel interface to application hardware and a UVC class USB port, allowing captured data to be transferred. The 32-bit parallel FIFO interface is for data streaming and there is a UART interface for control path configuration. Typical applications for the FT602 would be a USB 3.1 Digital Video Camera Interface or USB 3.1 Digital Camera.
Note that we have other SuperSpeed USB 3.0 solutions - The FT600 (16-bit FIFO Bus) and FT601 (32-bit wide parallel FIFO interface) supports 2 parallel slave FIFO bus protocols, with data bursting rate up to 400MBps.
If you want to send an email to support1@ftdichip.com I can provide some additional information.
Regards,
FTDI Community
The FT602 UVC Class SuperSpeed USB Bridge device provides a 32 bit parallel interface to application hardware and a UVC class USB port, allowing captured data to be transferred. The 32-bit parallel FIFO interface is for data streaming and there is a UART interface for control path configuration. Typical applications for the FT602 would be a USB 3.1 Digital Video Camera Interface or USB 3.1 Digital Camera.
Note that we have other SuperSpeed USB 3.0 solutions - The FT600 (16-bit FIFO Bus) and FT601 (32-bit wide parallel FIFO interface) supports 2 parallel slave FIFO bus protocols, with data bursting rate up to 400MBps.
If you want to send an email to support1@ftdichip.com I can provide some additional information.
Regards,
FTDI Community