FTDI Community

General Category => New Member Introductions => Topic started by: josked on October 20, 2020, 01:53:23 PM

Title: Hello from the Netherlands
Post by: josked on October 20, 2020, 01:53:23 PM

Hi everyone,

I,m using the VNC2-32L1C in a unit for reading and writing from and to a USB stick.
Mainly mp3 files to play.
Till last year I did the production myself, but due to increased production numbers, production is now transfert to a production facility.
For production I'm developing a test and programming device, to make it a smooth process.
To make it a "start whit one button" process, I would like to implement the programming of the VNC2 in my own process.

I'm looking for the protocol to program the VNC2 through the Debug port.
Could anyone help me with this?
I've looked on the website but could not find what I'm looking for.
I understand, that it is a normal serial port, with RX and TX combined.
What is the Boudrate?
And what are the commands to get this going? etc.

best regards,
Jos Knoop.

Title: Re: Hello from the Netherlands
Post by: FTDI_USA on October 20, 2020, 05:59:09 PM

Jos:

The following applications note describes the programming protocol for the VNC2:
https://www.ftdichip.com/Support/Documents/AppNotes/AN_118_Migrating_Vinculum_Designs_From_VNC1L_to_VNC2-48L1A.pdf

Feel free to continue our conversation by email:
us.support@ftdichip.com

Best Regards,

FTDI_USA

Title: Re: Hello from the Netherlands
Post by: FTDI Community on October 21, 2020, 04:36:31 PM

Hello,

You have already emailed our support1 team and we have replied with options available to you.

Feel free to post any additional information here to help other community users.

Best Regards,
FTDI Community

Title: Re: Hello from the Netherlands
Post by: josked on October 22, 2020, 03:31:18 PM

Hello,

Thanks, it never occurred to me to look here. This will get me going.
One question still, I assume the boudrate starting-up is 115200?

thanks.