FTDI Community
General Category => Discussion - Hardware => Topic started by: jimbuk2 on December 18, 2020, 10:14:56 PM
-
I want to use Channel A in FT245 Synchronous FIFO mode for bulk data transfer from an FPGA to PC. I want to use Channel B in MPSSE mode to send registers to a few SPI devices and use the GPIOs as enable and switch lines for other ICs. I know that Channel B is unavailable while Channel A is in FT245 Synchronous FIFO mode. However, if I assert my Channel B GPIOs prior to switching over to Sync FIFO mode will the Channel B GPIOs hold their state?
-
Hello,
Yes you can find details of the behaviour of the Port B lines in chapter 4.13 of this datasheet below:
https://www.ftdichip.com/Support/Documents/DataSheets/ICs/DS_FT2232H.pdf
Hope it helps,
Best Regards, FTDI Community
-
Great- sorry I missed that. Thank you for the reference and the reassurance.