FTDI Community

General Category => Discussion - Hardware => Topic started by: Anshumantech on April 17, 2021, 06:50:49 AM

Title: FT232H is not detecting in FT_Prog
Post by: Anshumantech on April 17, 2021, 06:50:49 AM

Hello,

I am using FT_Prog to program EEPROM of FT232H based PCB module.
I tried to program EEPROM using FT_Prog it programs well and gives message that Finished programming and Ready after that when I reconnect my device to PC and scan in FT_Prog it just shows Ready message at bottom but device is not getting detected. FT232H was working with Spartan 3, 6 up to yesterday, I programmed it using FT_Prog and suddenly it happened.
Why this is so? Is my device is damaged? How to check this?
Please help in this.

Title: Re: FT232H is not detecting in FT_Prog
Post by: FTDI Community on April 20, 2021, 04:52:08 PM

Hello,

Please email your local support team where we will send a utility to output all the USB parameters which will help debug what the exact issue is:

https://ftdichip.com/technical-support/ (https://ftdichip.com/technical-support/)

Best Regards,
FTDI Community