FTDI Community

Please login or register.

Login with username, password and session length.
Advanced Search  

News:

Welcome to the FTDI Community!

Please read our Welcome Note

Technical Support enquires
please contact the team @ FTDI Support


New Bridgetek Community is now open

Please note that we have created the Bridgetek Community to discuss all Bridgetek products e.g. EVE, MCU.

Please follow this link and create a new user account to get started.

Bridgetek Community

Show Posts

You can view here all posts made by this member. Note that you can only see posts made in areas to which you currently have access.

Messages - perrizozach

Pages: [1]
1
Discussion - Software / Re: Vinculum ii dubugger doesn't stop at breakpoint when running
« on: May 14, 2021, 03:22:44 PM »
When I click Verify, a message appears that says "Device has wrong version of Prog_Loader. Please contact support1@ftdichip.com for update."

I'm using version 2.0.2-SP2.

My V2EVAL is rev2.1.

After some searching on FTDI website, I downloaded the application "FT_PROG" to try another method of loading .rom files, but so far this method has not been successful either.

Specifically, the error message "The handle to the device is invalid" shows up, or the programming stops at "setting baud rate" and the program stops responding.

Is there a link to an updated Prog_Loader I could use?

Thanks

2
Discussion - Software / Re: Vinculum ii dubugger doesn't stop at breakpoint when running
« on: May 05, 2021, 05:16:39 PM »
Thanks for the response.

I'm using the V2EVAL board with a 48-pin VNC2 debugger module. When connected, the debugger interface reads:

"V2EVAL Board C-307
FT0H3TAJC
VNC2 48-pin package"

I've tried running a few different sample projects such as "USBHostGeneric", "ButtonsLights", and "HelloWorld", but get the same problem every time.

I set a breakpoint at an early executable function (such as a function call) and the program runs, without halting, with no uart response or otherwise.

In the Build Configuration section, I've set the mode to "Debug".

The IDE reports that it has successfully written data to chip when I hit "flash", and likewise for connecting to debugger when I hit "start".

Thanks

3
Discussion - Software / Vinculum ii dubugger doesn't stop at breakpoint when running
« on: May 01, 2021, 01:54:44 AM »
Hello,

I'm trying to get ANY project to run on my VNC2 debugger, but it appears the program doesn't even begin to run. When I select "start", the debugger LEDs flash normally, but when I create a breakpoint it never halts. Even if the breakpoint is the first executable action, the debugger doesn't halt. Is this a common error?

Any advice helps.

Thanks

4
Discussion - Software / Vinculum ii debugger does not recognize V2EVAL board
« on: April 19, 2021, 04:13:59 PM »
Hello,

I'm trying to set up my debugger interface with Vinculum ii, but the IDE "debugger interface" section says "disconnected", and when I scan for devices it searches for about two full seconds before returning "no devices found".

After installing a driver, my computer recognizes the board I've plugged in is an FTDI device (even though it is connected through one USB port, my device manager reads that there is an FTDI device on two separate COM ports).

The board is set up with the 48 pin daughter card, and receives power from my computer. When I scan for devices in the debugger section, the board's Tx LEDs blip faintly (all of the top LEDs light up brightly when I turn on the board, but other than that don't turn on save for this occurrence).

Any suggestions are appreciated.

Pages: [1]